Download a Quick Reference Guide in .doc (262K) or .pdf (160K) format. |
|
General
- When using the Duct Wizard with a truckmount or portable system, you must use a Hydro-Force Dustdowner (AC18) to protect the blower of the extraction equipment.
- Plug
into 110-115 volt (household) power outlet.
|
|
Brush Attachment
- Brushes twist
on right handed. Screw goes in and tightens left handed.
- While running brush head on a job, check for tightness several times. Brush may tighten while operating, which may loosen reverse thread (left-handed) screw, so check periodically until seated.
- Turn brush head clockwise until tight, then install reverse thread (left-handed) locking screw until tight.
|
|
|
|
|
|
Remote Control/Remote Board
- When fine-tuning remote board, hold down the power button on remote and fine-tune with plastic screwdriver only (included). Hold remote 3 feet away, then hold down power button until unit responds. It may be better to fine tune the unit without a hose probe attached.
- Note: Receiver may not work or have bad reception around TVs or running microwaves, etc. In that case, switch to manual operation.
|
|
|
Precautions
- Don't submerge in water.
- Included canvas bag is used for transporting the hose. Carrying the Duct Wizard in the bag may damage the hose.
|
|
