| BDW-66
|
Bridgepoint Duct Wizard |
|
Brushes
In addition to the brush sizes below, we can fabricate
brushes of special sizes upon request.
Note: It is very important to use
the appropriate brush size to prevent the motor from overheating.
If the clutch continues to slip during use, switch to a
smaller brush. |
| BDW-66:36 |
Standard 6 inch brush
(Recommended for vents 6 inches or smaller.) |
|
| BDW-66:33 |
Standard 9 inch brush (Recommended for vents
7 inches or larger. Also suggested for soft, plastic vents.) |
|
| BDW-66:40 |
Narrow floor opening vent brush (For openings
as small as 2 inches.) |
|
| BDW-66:35 |
Clothes dryer vent brush |
|
| BDW-66:32 |
Collector vent brush (12 and 14 inch sizes) |
|
Other
Replacement Parts |
| BDW-66:1
|
Lid with handle |
|
| BDW-66:10
|
Fuse housing assembly |
|
| BDW-66:11
|
100 AC power cord |
|
| BDW-66:12
|
Female receiver located on the right side |
|
| BDW-66:13
|
Switch located on the left side |
|
| BDW-66:14
|
Receiver board located at the front |
|
| BDW-66:15
|
Complete hose assembly |
|
| BDW-66:16 |
50 foot wire for Duct Wizard through hose |
|
| BDW-66:17 |
Hose with cuffs |
|
| BDW-66:18
|
Left-Handed locking screw |
|
| BDW-66:19
|
Male power probe |
|
| BDW-66:2
|
Right side panel |
|
| BDW-66:20
|
Resistor in probe |
|
| BDW-66:21 |
Motor and mount assembly |
|
| BDW-66:22
|
Transformer |
|
| BDW-66:23
|
Relay |
|
| BDW-66:24
|
Capacitor switch |
|
| BDW-66:25
|
AC to DC bridge |
|
| BDW-66:26 |
Wire kit |
|
| BDW-66:27
|
Hand-held remote control |
|
| BDW-66:28 |
Hose bag |
|
| BDW-66:29
|
Brush head |
|
| BDW-66:3
|
Left side panel |
|
| BDW-66:30
|
12 Volt - 23 A Battery |
|
| BDW-66:31 |
Plastic screwdriver to adjust receiver |
|
| BDW-66:39
|
Motor trance and clutch assembly |
|
| BDW-66:4
|
Front panel |
|
| BDW-66:5
|
Back panel |
|
| BDW-66:6
|
Base nylon plate |
|
| BDW-66:7
|
Lexan cover with stud kit |
|
| BDW-66:8
|
2" tube through cabinet |
|
| BDW-66:9 |
Nut and stud located on the front of the Duct
Wizard |
|
